where do we connect tap of tap changer, to H.V. side or
L.V.side? and why?
- 5 Answers
- 12937 Views
- Vedanta, I also Faced
- E-Mail Answers
Answer Posted / veerendra shah
always provide tap changer on hv side becouse
1.hv winding outside the lv winding easily we connect.
2.small current flow through it as compared to lv winding.
3.smoother control of the output voltage bcoz large turn ratio
| Is This Answer Correct ? | 8 Yes | 2 No |
Post New Answer View All Answers
how can calculate resistance box for 15 kw, 6 pole, RV-230, RA-42 motor
High speed earth switch operation with diagram
how to synchronize 3 phase slip ring induction motors of different ratings.
Why do not we prefer non conventional sources of energy to conventional sources?
how to modify DOL control panel into Delta Y connection?
why single CT used in DOL starter power circuit?
Draw torque - speed curve and load curve of induction motor? mark operating point ?
it is possible to rotate the DG engine dc starter with wrong polarity connections? why?
If we have to find the inductance of a dc shunt motor then by giving dc supply or ac supply and what is the reason for it. (this example is from "to determine the transfer function of a dc shunt motor ")
What are the main advantages of bode plot?
is there any phase difference occurs while primary and secondary side mutual induction occurs?
How to identify the start and end of 3phase 12 lead motor if U1, U2, etc numberings are lost or erased.
what are the tests comes under the type test, what tests comes under routine tests.
we have require a Motor (1500kW, 6.6kV, 50Hz) which shall operate at 1500rpm during 30min and after it shall run on 500rpm during 15min. The same cycle shall be repetitive during the whole working days. Which method is best and economic to achieve such type of task. VFD, VVFD, Pole changing motor etc.
How can we increase the capacity of Energy.?
