What is the ratio of Grades M10,M15,M20,M25,M30,M35,M40.
Answer Posted / brajesh kaurav
ratio of M10-1:3:6
M15-1:2:4
M20-1:1.5:3
that rattio is nominal mix basis.above M20,than mix design
is preford.basically M25 consider is 1:1:2
Is This Answer Correct ? | 3287 Yes | 307 No |
Post New Answer View All Answers
what post do you prefer to work in this company and why do you think you can serve better in such position?
What is an object snap mode?
How much time Required for PPR pipe network testing
How many Rod required for 58 feet by 24 feet roof slab which is supported by 5 * 3 = 15 Column. Six Stored building Roof Slab = ? Ton 15 Column = ? Ton Slab Beam = ? Ton
suppose we have a tendency to make a hole on the surface of the simple supported beam, than where we goes to make it?
Mention what are the composition of a landfill?
What is the requirement for over all CG of DG from the foundation surface to absorb the vibration of heavy set.
How you read 5x3x1 #4 @ 20" 0/C in steel structure?
Define current ucs?
how can calculate cutting length of diamond ring
A 16 pile group, consisting of diameter concrete piles, were cast in situ in a clayey soil whose unconfined compressive strength is 1100 psf. Each pile is 60 ft long and the pile spacing is 2.5 times the pile diameter.The water table is at the ground surface and saturated unit weight of the clay is 118 lb/cu.ft. using a factor of safety 3 and a reduction factor =0.45, compute the allowable capacity of the piles acting as individuals
How to increase a bearing capacity of soil?
what is tension & compression of steel bending.
What is meant by solid geometry?
residential buildings,mixing of concrete,structural,construction material,site handling.