Interested to Buy Any Domain ? << Click Here >> for more details...
Describe how to calibrate various types of instruments and
transmitters using ISA industrial consensus standard
techniques.
- 4 Answers
- 16825 Views
- Reliance, I also Faced
- E-Mail Answers
Answer Posted / amith.patil17@gmail.com
Calibration Can be Carried out By Calibration Instruments
such As For Pressure Transmitter,level transmitter the
pressure pumps with mA in Series or Can be used simply
HEART with a Pressure pump,By increasing the pump pressure
the master guage shows the indication of the Standared
pressure Corresponing to which mA reading canbe Obtained
check for incrasing and decreasing Valus for 4,8,12,16mA If
Error Occurs then Set a Zero or Span Adjustment,Simillarly
For RTD,T/C in Furnace is Carried out.
| Is This Answer Correct ? | 16 Yes | 1 No |
Post New Answer View All Answers
what is wave length were using ?
TEMPERATURE VARIATION FOR FREQUENTLY.
where are following valves are applicable to install. can any valve be installed any line. globe valve butterfly valve boll valve gate valve
selection of the zener barrier for the hazardeous area zone 0
NPN transistor, SCR, Zener diode, LED, Varactor diode, Vortex meter, RTD, Resistor, Crystal
Manipulation of dead wt. tester double piston type.
Can any body help to get Rsemulator 5000 free from internet if possible then give me any link or any help .
How to do gas analysers calibration in AUTO and Manually by using zero and span gas?
WHAT IS THE DIFF. BETWEEN SKIN TEMPERATURE AND PASSES TEMPERATURE..?
Can u tell me the principle of the tc,rtd,level switch,pressure switch ,transmitter(pr flow level temp.),vibration...plz
What is heating effect?
Q-Explain the different load conditions that will produced different offset which may or may not be acceptable to thhe control function
how will you segregate the alarm levels in alarm management system during factory Acceptance Test
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
i hav applied for the post of engg. in iocl so please require the past test papers fro instrumentation engg please please help me and send me the papers or tell me the pattern and type of ques asked in examination......
