will the introduction of capacitor bank parallel with the
induction load reduce power consumption
- 4 Answers
- 7860 Views
- Nokia, WAPDA Water and Power Development Authority, I also Faced
- E-Mail Answers
Answer Posted / pillay
Power is calculated for a 3 phase cct
as 1.73 x voltage x ampere x pf.
when cap is connected in parallel the PF
is improved but the actual current is
reduced proportionately so I dont see
any power being consumed less
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How can we calculate cable size in Low voltage & high voltage
CALCULATE THE TOTAL VOLTAGE DROP AND SELECT THE CABLE SIZE IN MM-SQARE FOR A PANEL-262KW AT 110 METER FROM THE SOURCE SUPPLY , SUPPLY VOLTAGE 240/415
Can any answer me ,What will be the range of C.T coil for L&T energy meter EM301 used for 180 kva DG set
why swityard is necessrry requirement in any bis power distributin systems?
How to checked frequency drive output voltages?
A 2083kva AVR was tested, phase to ground shows continuity, what is the implications
how to test and calculat the head and discharge in borewell compressor
how the characterstics of control valve being done
PLZ SEND ME SOME UNIQUE PROJECT OF ELECTRICAL ENG (B.TECH)
what is the size of ht cable of 33kv ht line and transformers ratings are 1 Mva and 5mva.please send formula also.
5.WHICH TYPE WELDING PROCESSES USES NON CONSUMABLE ELECTRODE.........
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
what is the value of combined earthing in general electrical circiut?
how to calculate micom relay earth falt time and current sertting
what is the solution for meger test failed the MV cable?
