in traction which type of supply are used
- 15 Answers
- 14247 Views
- APGenco, Construction, I also Faced
- E-Mail Answers
Answer Posted / r.manikanta
in railways the supply must be constant.in ac supply the
losses are more due to corona, proximity,feranti effects.so
the power loss is more that's way we use DC supply
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
sugest any typical project ?
Differentiate between induced emf and self inductance?
What will happen if the voltage in my house drops from 220V to any lower voltage?
Refernce currents are to be generated using refernce cueernts how can this be done
DEAR SIR/MADAM,CLEARLY EXPLAIN ABOUT CRAWLING AND COGGING EFFECTS IN INDUCTION MOTOR.
ult of expression 'document.FrmQF.myem
what is the basic need of domestic loads 1- voltage 2- current
Do closed loop systems require manual input?
ratings of lightning arrester
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
in an electronic tri vector meter when the current and voltage sequence changes ? what is the effect of phase sequence on recording of meter
(1)The demand for electricity , the amount of renewable generation available, the amount of fossil fuel generation available and the cost of the fossil fuel generation are shown in table below period(hrs) demand(MW) renewable (MW) fossil- fuel(MW) cost of fossil fuel(MW) 00.00 - 01.00 2000 1800 2000 30 01.00 - 02.00 2300 2500 2000 30 02.00 - 03.00 2500 2700 2100 45 03.00 - 04.00 2900 3100 2100 50 04.00 - 05.00 2700 2600 2500 45 05.00 - 06.00 2400 2000 2700 50 06.00 - 07.00 2200 1800 2000 36 07.00 - 08.00 2100 1600 2000 36 Assuming that the renewable generation incurs zero cost, determine an optimal generation schedule(specifying the amount of renewable generation and fossil fuel generation used in each period, the cost for each period and the overall cost for 8 hours.)
100 MVA 3-phase alternator with earthed neutral has a reactance of 5 ohms per phase. what will be the fault MVA of generator.
what are all the components required to assemble solar panel other than pv cell?
if i get a drop in my 1st year and the i clear my 2nd year and 3rd year all clear and i dont have any back logs so can i be able to sit in campus selection??
