what is the difference between switch and router??
Answer Posted / nandnu
Router --- Layer 3.
Switch --- Layer 2 ,Layer 3.
Layer 3 device__router :-
performs packet switching, packet filtering,path selection.
It is used to interconnect logically separated networks and
keeps record of all connected networks with the help of
routing protocols.
Layer 3 Device_Switch :-
does not support as many routing protocols as router does,
NATing and WIC configuration is not possible,
Help for inter VLAN routing only.
Layer 2 switch :-
hardware base machanism,
Is This Answer Correct ? | 22 Yes | 6 No |
Post New Answer View All Answers
What is the command for change serial cost?
what is the difference between a ‘half-duplex’ and a ‘full-duplex’ system?
After how long eigrp protocol advertise its routing table?
Tell me which protocol comes under hybrid dynamic type?
How many ports are present in a router?
in stead of 0.0.0.0 wild card mask what u can write after ip?
Differnce between the communication and transmission?
How do you depict an IP address?
In how many ways you can access router?
What is the difference between cross cable and straight cable?
Explain the difference between tftp and ftp application layer protocols?
What do we check while configuring the server?
GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong
Tell me which protocol works only on cisco routers?
What’s the easiest way to remotely configure a router?