Answer Posted / jayashree
With Gear hobbing process toothed wheels of gears are manufactured with high quality and gives excellent performance. Hobbing is only used to produce spur and worn gears. Internal gears or shoulder gear cannot be worked up in Hobbing process.
Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
HOW LIGHTENING PROTECTION IS DONE ON ROOF OF SQUARE SHAPE AND HAVE PARTUCULARLY BIG SURFACE AREA.
what type of questions will be there in the written paper of tata motors ?
What is the difference between Over Molding and insert molding ?
What are the important operational performance parameters in design of fuel firing equipment ?
Causes of emergency trip of diesel engine
Why and what cause of leak fuel oil in high pressure pipe of main engine?
What was the hardest part of obtaining your engineering degree?
How the net work to drive a compressor and its volumetric efficiency behave with increase in clearance volume ?
How do you calculate cooling energy?
At 50 Centigrade (Fuel oil) what is its cast?
what is the basic optimal difference among isothermal,isentropic and adiabatic processess( with charts of each)??
Critical speed of turbine means the natural frequency and resonance frequency are matching and cause for vibration and noise. which is the natural frequency. how it reflect in vibration.
difference between microcontroller and microprocessor
whats the coloring code of a air to open or a air to close valve?
Sir Plz Send me the questions of interview of Mechanical stream for ONGC