If mVolts can drop by resistance of wire as compare to mA,
then how thermocouple mV reaches in CCR as accurate value?
- 7 Answers
- 8258 Views
- I also Faced
- E-Mail Answers
Answer Posted / ponnamalla venkata satish
thats why we use single stand not multi core cable for
thermocouple measurement
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
all questions related to instrument technician in any offshore oil and gas company.
Calibration procedure for Electro magnetic Flow meter
How to work temperature gauge?
What is the meaning of wet leg
can any one explain in which term we are flow flow is it volumetric r is it mass? and y
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
Why upper weighing limit of electronics balance is 90% of the total weighing capacity?
May I have a brief note above the voltage barriers? Whats is the purpose? Please mail me if you've operational details, mail id: rajkumar.diice@gmail.com
we want to control pump in let pressure and tank (for exp) our inlet line if water cam and pump will on and when our tank will full pump will off also if our inlet pressure low pump will off even tank not full.this pump i want to uses on our water supply line.
is motorized valve closed when power shutoff?
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
i need some objective type questions in instrumentation
NPN transistor, SCR, Zener diode, LED, Varactor diode, Vortex meter, RTD, Resistor, Crystal
what is Best Among SINK Or SOURCE Type Design In Digital Signal, Either Iput Or Output? WHY?Can any one..
