Answer Posted / sindhejs
To find the resistance of the conducting device, apply the
ohms law to it. That is connect the voltage source to it,
apply the voltage and note down the current and volotage.
By using the formula V=I*R, calculate the Resistance R.
Is This Answer Correct ? | 13 Yes | 0 No |
Post New Answer View All Answers
State the methods of improving power factor?
Explain the experiment on ward leonard method of a speed control on a dc shunt motor with an suitable circuit diagram.
What are steps to be taken while designing of DYN11 distribution transformer to achieve magnetising balance?
Pl. share your experience about industrial-electronics repair of machine tool.
When lag/lead/lag-lead compensation is employed?
Can a generator runs after getting 1st stator earth fault.
How many Zones can be in Conventional type fire alarm system & how can we detect the fire in Conv. type FAS?
What is the height of DA, DAL, DB, DC & DDE tower?
how much LT load can bear by the 100 KW HT connection.
what is control supply rating of a machine
During Testing of Maintenance Free Earthing, How deep should be the Spikes of Earth Test Meter should be inserted in the soil(one spike is 15 Meter & Other spike is 30 Mtrs away from the Main Earth Electrode. Because, recently, we observed that when spike is inserted 3-4 Inch in the earth- results are better, If spike is inserted 1 feet deep than results are increasing.
what is meant by carrier aided trip protection in transmission line
Explain advantages of storage batteries
What is the difference between in Fourier series and Fourier Transform. and please tell me the difference between both of them and the why we use them in communication system?
What is the most important precaution in any experiment with d.c. Shunt motor?