What is BKW of Motor. And what its significance
- 1 Answers
- 32615 Views
- CGL, PK, Thermax, I also Faced
- E-Mail Answers
Answer Posted / jaggannath swami
b for wht u did not clearifed In my opinion BKW means breaking kilowatt. motor run when we stop the motor its produce some heat to use of stopping the motor than this typwe of regenerating the back energy to oppose the motor motion & its closed to stop
| Is This Answer Correct ? | 13 Yes | 44 No |
Post New Answer View All Answers
WILL SCHNEIDER MAKE ACB(MASTERPACT)TRIP ON REVERSE POWER?
Show the schematic arrangement of diesel power station layout and give its principle of operation.
Match the following a)(X'+Y') b)X'Y' C)XY 1)NAND 2)NOR 3)Carry
If UG power cable both ends are to be earthed or what? If not why?
Why front mounted CT polarities are always towards breaker?
Why CBCT rating is 50/1A
how to build a network which step down 415v to 1v rms
when measure the core loss of three phase distribution transformer or three phase reactor loss, one phase shown negative watt loss. why??
During FEED, you will have all the information with regards to cable. How will you calculate the MTO for MV and LV Cables? what are your considerations?
what is the IS foe lightning arrester?
one split ac how can told of this ac which Tr tell me us
What kinds of decision are made about CT from it's Knee point(voltage & current)?
to vary valtage from 0 - max a variac is necessary . so how to design for high power applications nearly about 200KW power
why the NGR (neutral grounding resistor) always OFF during DG off?
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
