what do we mean by hook up drawing. what r the information we
get from it?
- 7 Answers
- 32239 Views
- Reliance, I also Faced
- E-Mail Answers
Answer Posted / janes
In any process Industry, Instrument to be mounted properly
to get the Correct Reading. Hook-up drgs provides detialed
information about Instrument Installation with respect to
the Process Fluid.
Also Hookup drawing is use to specify the Scope of Piping
Department and Instrumentation Department.
Also Hookups are required for Operation and Maintation.
It Provide the the details of Bill Of Materials..
| Is This Answer Correct ? | 12 Yes | 1 No |
Post New Answer View All Answers
what is loop1 and loop2 in MTS LT?
hello sir/madam, I,Subramanian need 5yrs placement papers of officer trainee of Instrumentation technology.pls send to this mail id mani_nxtgen@yahoo.co.in please do the needful. with regards, subramanian.v
what is instrument philosophy
If we increase only P what will be controller action ?
What is difference between “Fault Tolerant” & “Fault avoidance” PLC? Application where these system s are used?
why we are using digital signals for I/O & how to measure this signals is getting or not ?
Define cryogenic?
Regarding , there is an air cooler which control the fans(50% of AV FANS) by temperature in outlet , and the louver of Air cooler is controlled by HIC from control system , So if on Air cooler we will consider 2 individual I/P converter or positioner?
what is orfics working in main steam line. is it increase pressure, velocity of steam flow and dicrease steam flow rate. or any other
give some question relative instrument fitter?
what is the working principal of pribe
Can Any body tell me how to check Modbus Settings in ER300N L&T trivector meter?
In Safe Guarding test what means by "Failed to Danger" ?
Linear amplifier.
why we are using magnet for calibration of gas detector?
