I am pujita completed Electronics and Instrumentation
Engineering.As a fresher i am going to attend the
interviews.Could anybody guide the topics/questions covered
mostly in interviews.
- 11 Answers
- 20654 Views
- I also Faced
- E-Mail Answers
Answer Posted / rathnakannan
control system,process control,integrated circuit is very
very important for interview, please learn only basic thats
enough
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
What is the function of solenoid valve in on/off & shutdown valve and why it is not used in control valve normally?
In Safe Guarding test what means by "Failed to Danger" ?
sir, i preparing hpcl,ongc,barc,hal exams(instrumentation engg)pls send a placement papers
I wnat to practice more online type questions .so will you show them me to take a practice test?
What are continuances of connecting earthing and shield of branch cables (instrument to Junction box), at the same earthing pot provided on JB? Is it ok, or may produce some problem?
why we use impulse line of flow transmitter at 45 deg. angle both side of orifice plate.
sir, give me placement papers and interview quistion of birla group company of copper.
What is force balance principle?
Hello to all....I am an Instrumentation Graduate and i am passed out in this year only.. I am unable to find the job in my core instrumentation.. so any boby tell me how to and where to search the job....please...and also tell me i there are any courses offered in the instrumentation stream so i can do it... you can send your suggestions to my mail-id i.e Ganesh20084u@gmail.com ... please..
why would you like to join our company
In bently nevada vibration monitoring system,what is the reason to maintain the Resistance of the probe + extension cable equal to 95 ohm? If possible explain the basic principle of measurement with detail electronic circuits.
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
Draw a wheatstone bridge circuit showing supply, meter and 3 wire RTD connection
components of control circuit belongs to control valve
Why all the drains(Gland sealing,ESV,Casing inlet etc) are directly connected to the flash tank instead of hotwell of the condensor in the power plant? My Email Id:naba02222@gmail.com
