what is difference between wheatstone bridge, pirani gauge
and strain gauge ??? explain its principle and working
Answer Posted / malhotra g singh
WHEATSTONE BRIDGE IS INVENTED BY WHEATSTONE.PIRANI GAUGE
AND STRAIN GAUGE ARE INVENTED BY PIRANI AND STRAIN
RESPECTIVELY.WHEATSTONE BRIDGE IS A BRIDGE WHEREAS PIRANI
GAUGE AND STRAIN GAUGE ARE GAUGES.
Is This Answer Correct ? | 3 Yes | 34 No |
Post New Answer View All Answers
i have been asked by QAFCO to appear for interview for thy post of Instrument Designer(INTOOLS)..i m engineering graduate with 5 years exp. in design engineering.Will this job profile suit me??i need all ur help n suggestions for thy same?
What is standard of DCS panel design?and what is step of DCS panel design?wiring and type of connector(screw or DB connector)
can any send me a forbes marshall dtron 316 manual
How to fix back the valve actuator stem
How d.p. Transmitter can be applied to close tank?
Type of level transmitter commnly used in Procees area are the following. a.________________This type of level transmitter works as follows
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
What are different types of orifice plates?
can we create an interrupt in plc through scada?
Why all the drains(Gland sealing,ESV,Casing inlet etc) are directly connected to the flash tank instead of hotwell of the condensor in the power plant? My Email Id:naba02222@gmail.com
you must show the examples application and give at least 4 types of transducer/sensors that can minimize the failure during the manufacturing of the resistors.
installation process of orifice,a question asked for confusion creation in interview by BARC 1.if orifice is tightly fitted with pipe ,it will act like venturi 2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,
when a magnet is heated?
What are advantages and disadvantage of the ac supply load cell?
what are the selections available in configuring a burnout protection of a controller? thanks