Interested to Buy Any Domain ? << Click Here >> for more details...
what do we mean by hook up drawing. what r the information we
get from it?
- 7 Answers
- 34826 Views
- Reliance, I also Faced
- E-Mail Answers
Answer Posted / maulik vyas
hook-up drgs provides detialed information about how to
install an instrument in proper manner..
it also includes the details of Bill Of Materials..
It is necessary document for project engineering as well as
maintenance dpt..
| Is This Answer Correct ? | 53 Yes | 3 No |
Post New Answer View All Answers
-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.
How to calibrate Magnetic flow Transmitter in Field
how to design orifice plate?what is the equation?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
How to Calibrate Vibration Probe (Axial, Redial) in field
why we are not using the turbine flow meter in the steam service?
i need some objective type questions in instrumentation
how to calibrate Necleuonic level transmitter.?
I have completed B.E. Instrumentation & control in 2009. i have 3 year industrial job experience in chemical plant.now, I want to join M.E. in external. so, Plese say easiet way and good institute name.
How to calibrate displacer type level transmitter (chemtrol make )for level measurement in hotwell , LP & HP heater ?
If fire would be inside the plant which fire detector is to detected the fire.
model question paper of instrumentation for Jindal GET 2010.plz reply sudhanshukumar08@yahoo.com
Im having problems with interfase betwen SPI v7.0 and SPPID v5.05. Previous versions of Intools shoul be fixed with SPPIDproj.ocx file. It was necessary to replace this file with one that allows the connection between different versions of SPPID. It is necessary in the current version to do the same?Thanks
what is the diffrence between pressure safety valve & pressure relief valve....pls
what is temperature compensation?
