in thermal overload relay class 10A indicate what
- 6 Answers
- 14088 Views
- Reliance, I also Faced
- E-Mail Answers
Answer Posted / jigs
10 A thermal over load realy that means it can be use to
protect the machine which rated current is 10 A & over this
current will operate & it will protect the machine.
| Is This Answer Correct ? | 14 Yes | 13 No |
Post New Answer View All Answers
what is the maximum permissible limit value of leakage current and leakage counter reading to replace lightining arrester?
What is VCB? where it is installed at SP. What is SP?
Apparent power is expressed as V * I(Conjugate). Why not in V * I ?
A 100 kVA , 400 v/250 kv testing transformer has 8% leakage reactance and resistance on 100 KVA base . A cable has to be tested at 500 kv using the above transformer as a resonant transformer at 50 hz . if the charging current of the cable at 500 kv is 0.4 A find the series inductance required . Assume 2% resistance for the inductor to be used and the connecting leads . Neglect dielectric loss of hte cable . what will be the input voltage to the transformer ?
Explain how to determine capacitor tolerance codes?
what is model question rrb junior engineer electrical gr.II
WE know that for Inductor X=2pifL,In DC f=0,then X=0 so,V=IX=0;But In the DC excitation of rotor of AC generator,DC motor field coil which coils are inductor so why does not applying DC voltage short the rotor coil of AC generator and field coil of motor?If it would then DC source might be damaged but it is not happened. Why does the strand conductor of Electrical power transmission line make twist?
Define conversion efficiency of a power amplifier.
How the over load setting for HT Motors calculated-provided in Numerical Relay
Define load factor?
Give some example of fault limiting devices?
when elecromagnatic waves are propogated in a wave guide?
why ss stablity limit is more transient stablity limit?
in ring main system we use the isolater b/w transfer bus and main bus if we r not use isolatar than wat will be the effect in our sys.
WHAT ARE THE DATAS REQUIRED FOR PROTECTION AND METERING AND CONTROL AND LOGIC PREPARATION,HOW TO STUDY THE PROTECTION AND METERING?
