why we step down voltage level from 33kv to 11kv and 11kv
to 415v.Instead we can step down voltage from 33kv to 415v
directly using single transformer.
- 12 Answers
- 69227 Views
- ABB, Adani, Central Electricals, Electrical, HCL, I also Faced
- E-Mail Answers
Answer Posted / gulshan goyal(knit->iitk)
distribution transformer energised 24 hours hence there
are continious core losses which in turn depends on
voltage.Hence to reduce core losses transformer is
energised 24 hours at lower(11kv) voltage.
| Is This Answer Correct ? | 12 Yes | 18 No |
Post New Answer View All Answers
why transmission is only 3 phase and not 2 or 4 or poly phases
Why does the speed regulating system adopting I controller have no steady-state error? In this single closed-loop speed regulating system, when the input of the I controller Un=0, what is the output voltage of the regulator? What factors do the output voltage depend on?
WHAT IS MOBILE SUB-STATION? & REALLY BENEFIT IN INDIA
what are the possible reaons & remedies if resistance of NGR getting heat up
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
What are the special cables required for explosion proof wiring?
Earth leakage relay basic knowledge principle
What are n circles?
what is droop control?
which type of effect of turbine and generator reverse power protection ?
What is the function of under voltage release ?
In the N-series schneider reclosers. What is the difference between current during fault time and current at tripping? This appears in the Event log in an event of a trip out.
PLZ SEND ME SOME UNIQUE PROJECT OF ELECTRICAL ENG (B.TECH)
Is Transol transformer oil comparable to nynas nytro libra?
sir iam from electrical and electronics branch ,can i appear for the hpcl offline requirtment? if yes please mail me on vikram_raju25@yahoo.co.in
