What is the differace between Volumatric flow meter and Mass
flow meter.
- 4 Answers
- 20620 Views
- Reliance, I also Faced
- E-Mail Answers
Answer Posted / yadav manoj
Volumetric flow meter gives flow rate in terms of volume
viz liters/hr,gallon, m3/hr etc whereas mass flow meter
(coriolis) gives direct mass flwo rate viz kg/hr/tons/hr etc
Usually mass is derived by multiplying volume with product
density.
volumetric flow gives how much volume is passing through a
given point,it does not give the real mass of fluid is
passing.Mass flow is highly depends on the density as well
as on temperature,change in these changes the mass flow.
| Is This Answer Correct ? | 10 Yes | 1 No |
Post New Answer View All Answers
what is a good line as ic engineer as maintenance ,oc, project, calibration ,validation engineer?
how to design orifice plate?what is the equation?
how to calibrate steam control valve in steam turbine
what are the steps I have to deal with?
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
Explain the working of an electronic level troll.
What happen if I install my pressure transmitter below the elevation of pipe in natural gas service?
Derive capacitance to 4-20ma conversion formula / relation in capacitance type pressure sensor?
what is output of FOUNDATION FIELD BUS transmitter
what is Best Among SINK Or SOURCE Type Design In Digital Signal, Either Iput Or Output? WHY?Can any one..
What pressure results for a flow transmitter of range 0- 180t/h in the dcs and 0-301mbar in the field using square root extraction. Kindly also suggest formulae for the percentages 0,25,50,75,100?
Im having problems with interfase betwen SPI v7.0 and SPPID v5.05. Previous versions of Intools shoul be fixed with SPPIDproj.ocx file. It was necessary to replace this file with one that allows the connection between different versions of SPPID. It is necessary in the current version to do the same?Thanks
key exchanges in wpa,wpa2,tls
which processor is used in dcs.
