working of a diesel generator.
- 34 Answers
- 168652 Views
- ABC, AC, Cognizant, CTS, Directorate of Lighthouses and Lightships, KSL, Quippo, Shree Renuka Sugars, SRF, Svam Power, Tech Mahindra, I also Faced
- E-Mail Answers
Answer Posted / manoj sharma
A diesel generator is the set of diesel engine and
alternator. Disel engine is prime mover which rotates the
alternator and alternator generates the electricity.
Further diesel engine works on principle of carnot cycle,
air is compressed in a cylender, then it is compressed up
to high pressure, disel is injected to this compressed air
thus cumbustion takes place,this energy force to move the
piston in the cylendrical passage, piston is further
connected to crank shaft. on the other hand generator
wotrks on principle of electo magnetic induction, when a
DC excited rotor is rotated then at synchonous speed EMF
induced in static armature.
| Is This Answer Correct ? | 265 Yes | 25 No |
Post New Answer View All Answers
What are the Full Forms of TVM, MTL, CVT ?
how many single tension hardware are required on a double circuit transmission tower?
which are the criterias needed to select the kind of neutral earthing(solid earthing,resistance earthing,etc.) at various voltage levels in electrical distribution?
How do u analyse protection fault when vcb tripping on load
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
what is the main difference between power devices and signal devices
what is subtransient , transient and steady stateac components
For group 1 , 2 whather i have to prepare my technical or general studies etc? and im graduate in ee engg. for wht posts im eligible for? please tell me!
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
what is arc flash and what are the hazards involved
I have a current transformer with 1 main reading meter with transformer outside the building and a control panel having 5 CT reading meters with black round coils inside the building. I want to know, A) when current pass through the Transformers, will the current be reduced or be the same and after that B) when current pass through the CT meters with black round coils, will the current be reduced or be the same. C) in the above process will the reading of the main meter be same or different, from the total reading of all the 5 CT meters.
What is the formula formula for Busbar sizing and what are the things to be consider for Busbar Calculation?
there is an alternator 480 k.w, 400v,50hz, 4-wire running on load having leakage alternator body earthed current 38 A. is it within acceptable limit? if yes then give reference if no then how to bring within specified limit
How many size of cable required for a 300m long and 30kw inductive lode
why we dont prefer ac voltage controller instead dimmerstat [if both have same rating] for conducting experiments in laboratories?
