Technician A says that a fuel tank sending unit will have a
high resistance only when the tank is full. Technician B
says that its resistance when the tank is full depends on
whether the sending unit is designed for use with a
bimetallic gauge or with a magnetic gauge. Who is correct?
- 3 Answers
- 7589 Views
- I also Faced
- E-Mail Answers
Answer Posted / jeevan
The resistance of fuel sending unit varies depends on the
position of the float material in fuel sender unit
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Displace type LT to be calibrated in workshop, wt. 40, dia- 60 mm, density- 0.8kg/cm3.
Using your own examples solve a problem involving normal table. (experimental method and analysis)
what is the importance of CV in the control valves? how it is calculated?
what should he know if he is an assitent engineer instrumentation in cement industries of experience of 10 - 15 year.
How to calibrate Toxic gas detector?
what is interlock system and why we use of this?
what is wave length were using ?
How the sizing of the analog signal cable is calculate?
why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?
In dcs panel we are using diff type of modules ?what is module ? what is the use of modules ?diff type of module?
Why we are using reverse action in displacer types level transmitters on some Vessels?
Manipulation of dead wt. tester double piston type.
what is a good line as ic engineer as maintenance ,oc, project, calibration ,validation engineer?
How u will setup SPI(2007) on Citrix Server (Thin Client Mode)? Plz Justify?
What is the Working principle of Dozing valve?
