why do we generate sinusoidal ac?can we generate some other
waveforms by alternators?
- 11 Answers
- 15484 Views
- Siemens, I also Faced
- E-Mail Answers
Answer Posted / fonzy umali
ALTERNATOR CAN ONLY GENERATE SINE WAVE THAT IS..0 TO 180
THEN 180 TO 360 DEGREES. DERIVE FROM THE ROOT WORD
ALTERNATOR MEANS IT VARIES FROM POSITIVE TO NEGATIVE WAVE
OR VICE VERSA..IT MIGHT PRODUCE RIPPLE DURING WHICH STATICS
OR HARMONICS BUT IT ALWAYS HAVE POSITIVE AND NEGATIVE WAVE.
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
How to find out damper winding failure for synchronous machine?
what is mean by descripiency relay? & wht is its ansi code?
What is gross error?
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
Please tell me the earthing procedures adopted for the STAR-STAR 3 Phase transformer in india and give a better sugession for earthing
What happens when two positively charged material is placed together?
How to know the following data of synchronous generator 1. D-Axis Unsaturated Reactance 2. D-Axis Unsaturated Transient Reactance 3. D-Axis Unsaturated Sub - Transient Reactance
how to check ac servo motor
how do u gauge the size of the cable ?for eg. consider a 300 sqmm L.T Cable.How do u determine the size of the cable seeing it pratically?
Define phase cross over?
1.what is difference in maintain Hz again Hz in USA ? 2.how to calculate the battery AH? 3.why are yearly maintained in transformer how many tests in required?
a battery is having capacity 100AH and 25% charging .if a load taking 10A & connected 6 hour .what is the final condition of the battery.
how to design the heater in temperature control unit to heat 50KL of water?
What is line resistance of cable & how it can be measured ?
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
