why earthing is not required on transformer prymary winding
side ???
Answer Posted / ankush miglani
the neutral is generated at the secondary side of the t/f,
so the earthing is done at sec. called the dedicated
earthing. but at the pr. side of the t/f no neutral is
generated hence require no earthing. but the body of t/f
is also earthed.
Is This Answer Correct ? | 18 Yes | 2 No |
Post New Answer View All Answers
we can run 2phase as 3phase .what will be the differnce with respect to phase angle, power, current between the two modes
what is metering cum synchronizing panel and how it is used?
how to CHECK CT AND PT AT THE FAULT OCCUR IN GENERATOR RELAY PANEL .
What is the difference between Static and servo controlled voltage stablizer?
Why is better to have a minimum ceiling voltage of 250% than 160%?
please tell me, how i clear the objective test? when i studied form the one book after i solved the objective ,that time i solved that qes. but if i tried solve objective form the other book then i could not solved these que.
for compensate 315mh inductance ,how many capaciance required?
In power transmission using open belts or horizontal shafts it is preferable to have the slack side of the belt on the top because
what does a k rating in a transformer means?
hi, in the event earth grounding is not available in a project, is there any other way to make the elcb work? fyi, i have an instant water heater (6.5kw) installed, however if there is grounding in the heating element inside the heater assembly, i will get grounded. thank you in advance to those who will answer my question.
what is the thumb rule for determination resistance of resistor?
please give me all the Alarm .Trip ,Safety Relays & Conditions of Diesel-generators mail me on ashokbabunhce@gmail.com
lamination figures
Where voltage are high and current to be interrupted is low the breaker preferred is:
How to calculate VA rating for CT or PT or Control Transformer?