Interested to Buy Any Domain ? << Click Here >> for more details...
Do you know how to measure the earth resistance? if so
explain it
- 42 Answers
- 179756 Views
- ABB, BEL, BridgeStone, College School Exams Tests, Dalkia, Dalmia Group, DEC, Electrical, Genpact, HEC, IOCL, JLL, L&T, MSEB, Saraca, Sical, Telecommunications, University Exams, I also Faced
- E-Mail Answers
Answer Posted / k.viswanathan
Actually the Earth resistance is measured using "earth
resistance meter". In previous answers some said that using
megger, but megger is used only for high resistance
measurement i.e., in Megaohms but when considereing upon
earth resistance it should not exceed 1ohm so earth
resistance meter is required.
In this meter there will be four terminals(E, P1, P2, P3)
in which E and P1 will be shorted and connected to the grid
or electrode and P2 and P3 are reference electrodes which
will be kept on the earth surface on two different
locations for taking the reference resistances of the earth.
The meter shows the resistance of the earth. But it is
neccessary that it should be below 1ohm
| Is This Answer Correct ? | 55 Yes | 12 No |
Post New Answer View All Answers
TRANSFORMERS WITH DC SUPPLY
What is the meaning of HT Trivector Meter ?
Whether the vacuum contactor requires Short circuit protection?If No,why?
how to revers the direction of single phase motor
how to choose cable size with respect to load? how to convert cable size in mm2 to sq.mm?
i have 3500 amp load and select current transformer and perches.how i calculate .please understand
why we are using Load factor?
How To Convert Apparent Into Real Power Without Knowing Reactive Power?
What is the magnetic field (coil DC ) of Turbo Expander?
Explain the purpose of inductor in an electric circuit?
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
Why GRR starts from 60% of motor speed why not less than 60%?
if we have a industrial load of 400 kilowatts with 415 volt AC then how much total harmonic distortion (thd%) should be acceptable for steady power system.
what is the difference between linear choke and suction choke?
please send me the previous year's question papers of jindal GET exams
