what is the difference between upper impedance and lower
impedance distance relay?
- 3 Answers
- 9941 Views
- Havells, Power Grid, I also Faced
- E-Mail Answers
Answer Posted / srikrishna kumar
the operation of the relays depended upon the magnitude of
current or power in the protected circuit. however,there is
another group of relays in which the operation is governed
by the ratio of applied voltage to current in the protected
circuit. such relays are called distance or impedance
relays. in an impedance relay, the torque produced by a
current element is opposed by the torque produced by a
voltage element. the relay will operate when the ratio V/I
is less than a predetermined value.
| Is This Answer Correct ? | 13 Yes | 11 No |
Post New Answer View All Answers
What is core CT & it's function?
why not starting switch first connect in direct on line starter?????
what is the relative size of single and three phase?
A 100KVA SINGLE PHASE TRANSFORMER 10000/200V,50HZ REQUIRES 300V AT HV SIDE TO CIRCULATE FULL LOAD CURRENT WITH LV SHORT CIRCUITED.THE INTAKE IS 1000W.THE % OF REGULATION ON FULL LOAD AT 0.8 PF LAGGING WILL BE HOW MUCH AND THE SECONDARY TERMINAL VOLTAGE ON 0.8 PF LEADING WILL BE
when the Transmission and Distribution network where is the "feeder" lines are located? and why should be used in T&D network.....
What is meant by celling voltage & current in excitor ?
define as synchronous generator
Define ampere
Why power factor should not be in leading (capacitive) mode of any load.
WHAT IS IEC? & WHAT IS BENEFIT TO PRODUCT FROM IEC?
could an induction motor be used for regenerative braking in electric-train control? in this type of application would some scheme have to be devised to obtain low synchronous speeds while braking? would induction-motor drive, therefore, be suitable for passenger service?
what is the range of maximum DOL and SDS can be use for pump and fan application
What type of DC motor would you see for a lift?
Mr. mohh sahid m not satisfied for ur answer to the que weather the size of transformer increases or decreases withchange in fr for more detail go to the answer given by me
What is meant by cold loop test in instrument
