what is mechanical advantage
Answers were Sorted based on User's Feedback
Answer / niraj mishra
hi pradeep ,the qstn is not about mechanical engg
advantage.mechanical advantage is defined as the ratio of
load to the effort.it can also be defined as the ratio of
output torque to the input torque.
BIT MESRA, RANCHI
Is This Answer Correct ? | 35 Yes | 0 No |
Answer / saumya ranjan khuntia
Hii Skhan407,
The formula for mechanical advantage is, it is
the ratio between effort to load i.e
M.A= (Distance over which effort is applied/Distance
over which load is applied)
or
M.A=(Output/Input)
Is This Answer Correct ? | 6 Yes | 0 No |
Answer / karthick
in simple terms it is defined as the load lifted to the
effort applied to lift the load.it is used in screw jacks
Is This Answer Correct ? | 1 Yes | 1 No |
Answer / chandan
we can get job anywhere through mechanical eng.
Is This Answer Correct ? | 1 Yes | 2 No |
Answer / arjun
ITS THE ADVANTAGE THAT MECHANICAL ENGG STUDENTS GETS DURING
EXAMS, BY GETTING THE CATALOUGES BOOK WITH FORMULAES IN IT.
WAT AN ADVANTAGE..
Is This Answer Correct ? | 0 Yes | 4 No |
Answer / pradeep
in mechanical engineering have many advantages in golg
futuer on many mehanical enginnering.. so we get good jobs
in hardweaer &soft wear both side wii be aparthuchinite in
mechanical engiineering. .
Is This Answer Correct ? | 0 Yes | 25 No |
For maximum capacity of compressor inlet temperature of air should be high, low, very high.
Tell me how many btu per hour equals 1 ton of air conditioning?
What are carvings in Ajanta Caves? a.Mahabarath b.Ramayana c.Jataka Tales d.Upanishads
What are the causes of positive and negative propeller slip?
What is torsional???
why we did't use petrol engine for haevy purpose...?
Causes of M/E high exhaust valve temperature
how do you differentiate the while look at drawing whether it is first angle or third angle projection.
Out of constant pressure and constant volume lines on ts diagram which line has higher slope ? And whether slope is constant or variable ?
WHAT IS MECHANICAL ENGINEERING
Differentiate between the uniform flow and non-uniform flow?
where impulse turbine & reaction turbine are used?