Answer / puviyarasu

Using multimeter

physical identification of HT & LT panel

0 Answers   Schneider,

---

why do select 11000v rubber mat even we use only 415Volts

1 Answers   Saint Gobain, Tata Steel Limited,

---

If increased the frequency up to 1000 then what changes shows in voltage?

0 Answers  

---

What is on delay and off delay timers

1 Answers   NCC,

---

It is used or not HT cable single core 630 sqmm in LT 3 phase capacitor bank which is used in PCC(power control center).

1 Answers  

---

When semiconductor fuse does save thyristor in each cycle of conduction? Why under voltage setting keep less in SPRS and more in DC drive?

0 Answers  

---

what is the difference between electrical and electronic choke?

0 Answers   TCS,

---

what will happen if u run induction motor beyond its rated speed

13 Answers   Adani, BARC, Bescom,

---

I want to know the standards for earthing system as per IEC, BIS & IEEE.

2 Answers  

---

what is name of transformer oil ?

58 Answers   L&T, MPSEB, OPTCL, Practical Viva Questions, Servo, TATA, XLPE, ZGL,

---

During Testing of Maintenance Free Earthing, How deep should be the Spikes of Earth Test Meter should be inserted in the soil(one spike is 15 Meter & Other spike is 30 Mtrs away from the Main Earth Electrode. Because, recently, we observed that when spike is inserted 3-4 Inch in the earth- results are better, If spike is inserted 1 feet deep than results are increasing.

0 Answers  

---

why we dont prefer ac voltage controller instead dimmerstat [if both have same rating] for conducting experiments in laboratories?

0 Answers  

---