Answer / s.senthil kumar

to reduce the noise and increase the efficiency

Answer / vijay shrichandani

turbo charger is a device used in the exhaust because
exhaust gases cause the shaft of tubocharger to rotate,
which is connected to the shaft of the compressor ,due to
which the compressor sucks more air and delivers the air at
high pressure

Answer / chetan

turbo charger are mainly used to increase efficiency also
it helps making the engine compact,it also helps in
redution costs.

Answer / kschari

Every body thinks that super charger increase the efficiency of the engine which is a wrong concept.The super charge increase the power to weight ratio but not the efficiency. The turbo super charger pumps more air (oxygen) into the cylinder so that more fuel can be burnt in the cylinder which increase the power so the same engine can develop more power by using the turbo charge compared to with out super charge, hence power to weight ration increase but not the efficiency

Answer / surinder rana

increase the efficiency

Answer / sudheer

Turbo charge is used / fitted to exhaust side of the DG set.
its function is to supply hot gases to engine for quick
ignition purpose. actually natural suction air from filters
are cold and takes little bit more time for catch ignition.

Answer / hardeep singh

turbo charger is a mechanism in which the hot gases from the
exhaust chamber in cylinder get recirculated again through
the cylinder, which increases in the performance and the
initial torque.

what is difference between pressure and stress?

6 Answers   MAHINDRA,

What is function (in details) room sensor and tube or coil sensor in HVAC system?

0 Answers  

how much power consumption takes for 2tr split a/c per one hour

3 Answers  

1.select bearing for flywheel to have a life of 5 years ? 2.select minimum diameter of the crank pin to work for at least 1 year? 3.select suitable belting to connect motor and pulley shaft(flywheel shaft)?

0 Answers  

what is procedure of measuring operating length of mechanical seal . (in case of centrifugal pump)

0 Answers  

Can you use motor oil in a hydraulic system?

0 Answers  

When can we using journal bearing and what is differences in duty between it and friction less bearing ?

2 Answers   NOC,

When I use two metal wire dowsing rods and walk over the septic tank,(or any other place where the ground has been dug up) they swing apart. What force causes them to move? magnetic, electrical, other?

1 Answers  

Explain the importance of thermodynamics laws in mechanical engineering?

0 Answers  

What are the advantages and disadvantages of gear drives over belt drives?

0 Answers  

What is torque converter?

0 Answers  

which type of air compressor is best between reciprocating and rotary. I used this compressor in our new mitsubishi type laser machine

1 Answers   Borouge, Sabic, Sail,