wt is the function of transformer?
Answers were Sorted based on User's Feedback
Answer / swathi
a transformer changes electricity from high to low
voltage.It s an electrical device used to convert AC power
at a certain voltage level to AC power at a different
voltage, but at the same frequency.
| Is This Answer Correct ? | 19 Yes | 3 No |
Answer / sirisha
The function of a tranformer is to tranfer power from one
ckt to another acting as a coulping device and high or low
output is obtained at secondary winding.
| Is This Answer Correct ? | 5 Yes | 0 No |
Answer / pawan
normaly transformer two type
1. stap up
2. stap down
So transformer work is premary volt to tranfer maximum volt
in secendry side without electrical cuch only transfer by
electrical wave.
| Is This Answer Correct ? | 2 Yes | 0 No |
Answer / vinit92
transformer will transfer energy from one circuit to another
circuit without any change in frquency.
frequecy will remain constant while transforming
| Is This Answer Correct ? | 1 Yes | 0 No |
Answer / rasna kaswan
it is used to step up & step down the voltage.there are two
type of transformer 1 step up 2step down
| Is This Answer Correct ? | 1 Yes | 0 No |
In wave guides tem wave propagation is not exit, give the physical interpretation?
IS THIS POSSIBLE TO VARY THE POWER BY VARYING THE FREQUENCY IN TANNER EDA TOOL..
how the silicon knows 0's and 1's...
internet applications work on which osi layer?
what your doing work capacity?
why we most prefer negative clock input(negative level) most in all flip flop answer
what is the difference between electrical and electronic choke.. and whats the main advantage of elecronic choke?
Why the width of the base region of a transistor is kept very small compared to other regions?
how the ac drive work
What are the main advantages of integrating type adcs?
Draw a schematic diagram of a Half Adder. Can you draw the same using only NAND gates?
In C language,What is the use of f in printf or scanf statement? Whether it indicates the function if so the brief explanation ortherwise what is the main reason behind that f in printf/scanf statements?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)