why ht alternators gland plats using brass?
It is rustproof . Being softer than iron ,adjusts to slightly uneven surface and fastening bolt & nut can be removed easily .
| Is This Answer Correct ? | 0 Yes | 0 No |
In a poly phase circuit if clamp on meter shows same load on three phases and their sum on neutral then why we use three and a half core cable or maximum the same size of core as that of phase?
what is the effect of power factor in electrical circuit ? if we mainten power factor near about unity (0.999) our energy consumption Units increase or decrease?
11 Answers Piramal Healthcare,
Why HT cable have only 3 core ?
IN a transformer during power supply how the LV and HV bushing works??
how to use single phase supply for a three phase equipement.
while starting a liquid starter ,is there any volage drop on water/soda on tank.can we touch the tank on starting?
defination of lines
which type of stability limit is higher,steady state or transient? why?
The power dissipated by a resistor of 10ohm when a current of 2A passes through it is:(a) 0.4W(b) 20W(c) 40W(d) 200W
Difference between rating factor of cable and derating factor of cable?
Explain Power factor in simple words
When motor stater and roter air gap do big then what will moter.
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)