Answer / rabi

20 micro ohm. it may be less than 20 micro ohm.

Answer / anurag chauhan

Contact resistence of breaker is depending upon how many contacts are comes between the contact resistence meter leads. Count the contacts and calculate the value accordingly 6 to 10 micro ohm for one contact.

Answer / gunasekaran

at the time of contact resistance B/W fixed and moving
contact it is accept up to 100micro ohm for new breaker for
fairly old one is 200 microohm

What is the purpose of starter and choke in tube light?

9 Answers   Chimay Brewery, TATA, TSPL,

---

What is the difference between Earth Fault protection & Neutral Protection

1 Answers  

---

What is online and offline ups? how does it works?

0 Answers   Call Centre,

---

what is the difference between unarmoured & Flexible cable? How to identified?

0 Answers   Priyanka Electricals,

---

How much amperes needed for starting of 4HP motor?

1 Answers   CM Smith Sons,

---

I am experienced with house and industrial wiring but I don't have any licence how can I apply an licence and which type of licence i can get i didn't complete deee just only experience

0 Answers   Future Electrical,

---

Discribe type of fault in DOL and stardelta startor.

0 Answers  

---

what is power factor? whether it should be high or low? why?

11 Answers  

---

what is induction motor

2 Answers  

---

which gas is cost wise high?

1 Answers  

---

What is mean by PID controller? And what is its Long form?

9 Answers   Jindal,

---

I am designing new project sub station with 220 kV / 11 kV, 40 MVA capacity. This project have many recifier sets, which can generate 3rd harmonics. Now I have to select vector group of This transformer. To minimise 3rd harmonics, what care should I take in selection of Transformer Vecrtor group? If it is Y-Y with open Delta tertiary then what should be the rating & voltage of Tertiary Winding?

0 Answers  

---