Answer / abdul quadir khumani

Diode is a Semiconductor having one p-n junction But in case
of SCR there three p-n junctions

diode can work in both direction but SCR works only in one
direction( i.e., P-N-P-N)

diode is combination of two semiconductors (i.e., p-type and
n-type), but SCR is a combination of two transistors (i.e.,
pnp and npn transistor)

diode always conducts if input is given to it but SCR don't
shows this property there are some method to turn ON or to
turn OFF the SCR (like using Gate Pulse method)

and there are lot of differance between DIODE and SCR

thanks, to give me opportunity to show my views

Answer / don devil

Diode is a two terminal device.
SCR is a three terminal device.

Answer / kingston

DIODE IS USED FOR FREE CURRENT FLOW BUT SCRS TRANSMIT POWER

Answer / jahangir alam

DIODE HAS UNCONTROLLED SIMPLE RECTIFICATION APPLICATION IN
LOW VOLTAGE AREA BUT SCR HAS CONTROLLED RECTIFICATION
APPLICATION IN VERY HIGH VOLTAGE ENVIRONMENT

Answer / ravi tamrakar

scr power handling is better than diode.

Answer / dinesh naika

Diode: 2-terminal, 1-junction semiconductor device. it has
no control on its conduction
where as SCR is 3-terminal,3- junction semiconductor device.
it has control over its conduction.i.e unless a gate signal
is applied it wont conduct

Answer / dillip kumar jena

Diod is a semiconducter device, made of Si,Ge etc..
sCR is made of only Si not any other semeconducter device.

How can I make calculation to Install level transmitter (DP) for open tank and close tank

0 Answers  

What amplifier

3 Answers  

What do you mean by effect of noise on carrier signal & what is noise segment

0 Answers   TATA,

what is the main diferance b/w the electronic and electrical?

5 Answers  

list the broad classification of adcs.

0 Answers  

why we not connect the 12 V batteries in parallel to get the more backup supply ? how to calculate the input wattage and output wattage of an UPS ?

1 Answers  

interface an 8-pin switch with 8085 microprocessor located at 0AAH and LEDs at port 55H, draw the circuit diagram. Write down a program to read the switches and do the following: > if the parity of the switch is odd, start counting upward until it reaches 0FFH. > if the parity of the switch is even, start counting downwards until it reaches 00H.

0 Answers  

draw the block diadrame and explain the working of proximity sensor

2 Answers   Infosys,

about your college

3 Answers   Infosys,

Wats da diff b/w ithernet communication and profibus communication?

0 Answers  

What is a rectifier?

0 Answers  

wat will happen to the windings if the required current is not given to a stepper or dc motor , but voltage is constantly applied to it below required current??

0 Answers   Freescale Semiconductor,