why moment is create in fixed beam. And why moment is not
create in simply support beam
Answers were Sorted based on User's Feedback
Answer / ka
in a fixed beam the fixed ends are restrained from rotation
as a result of which a reacting moment is created but in
simply supported beams the supports are free to rotatein
the plane of action of load so there does not exist any
reacting moment
Is This Answer Correct ? | 43 Yes | 4 No |
Answer / dunstan
fixed end are restrained for all degree of freedom
therefore create moment, but simply supported end(pin
joint)is free for rotation. therfore no moment.
Is This Answer Correct ? | 22 Yes | 2 No |
Answer / ppl
Positive moment (with tension in the bottom) is created in
both simply supported and fixed beams which are loaded by
gravity. However, this moment is less in fixed beams, since
a fixed support is made to resist some of the moment in the
beam. As the other answers partially said, negative
moment(with tension in the top) is only created in fixed
beams because of the moment resistance in the connections.
True simply supported beams do not have negative moment
because by definition, their connections do not resist moment.
Is This Answer Correct ? | 10 Yes | 1 No |
in case of fixed baem, both ends of beam are fixed & in order to make unit slopes in the end ,moment is acted..but in case of simply supported beams as ends are free ,therefore no moment is acted.
Is This Answer Correct ? | 1 Yes | 11 No |
what discoveries did you have in relation to your course?
What is an object snap mode?
insted of bentonite we can use any alternate material in piling ?
WHAT IS THE LAP LENGTH FOR COLUMN WITH DESIGN MIX M-35 RCC
7 Answers Omaxe, Shoba Devlopers,
how to calculate cost for MS plate shuttering (show calculation/assumptions)
how many meters for brad gauge?
for G+2 residential building how much quantity of required in foundations,sub & superstructures per sq ft area
how can change 10mm dia @275 c/c bar spacing to 12 mm
How to increase a bearing capacity of soil?
how we decide the thickness of slab
if i want to change the dia of some bar in a structure,then which formula should be used to find the spacing for the bar of new dia?
what is the difference between natural draught cooling tower and induced draught cooling tower