Answer / md gulam moinuddin/laxmikant p

Sewer is the structure which is used for the purpose of
disposal/flowing of Raw water

Sewege is the waste water coming from w/c or such dirty
water with bad smell

Answer / baskar

1)sewer is a underground conduit or pipe used to removal of
sewage.
sewage is defined as a disposal of untreated water
(bathing,flushing,etc...)
storm water is called collection of rain water
2)nominal bricks sizes 19cmx9cmx9cm
standard bricks sizes 20cmx10cmx10cm
3)the different between the grade of cement 43,53,that is
comperssion strengh of concrete.

Answer / sreenu b

1 Sewer is the structure which is used for the purpose of
disposal/flowing of Raw water

Sewege is the waste water coming from w/c or such dirty
water with bad smel

2 standard-19cmx9cmx9cm
normal-20cmx10cmx10cm

3 1. Fineness of cement. 53 grade fineness compare than to 43
grade cement.
2.compressive strength of concrete.
3.Low content gypsum so, 53 grade Fast Harding compare than
to 43 grade.

Answer / elanthendral m.

Q3: Grade cement is 28th day compressive strength of Cement
mortar cube (Mix is 1:3 with graded sand). If it is 43
grade cement and it should be more than 43N/mm2 (Mpa) of
430Kg/CM2. If it is 53grade and it should be 53N/mm2 (Mpa)

How do you calculate the mix ratio of concrete i.e. what is the cement:sand:agrugate ratio in 20Mpa, 21Mpa, 22Mpa etc...

2 Answers  

---

important question on stones

0 Answers  

---

What will be the crank length in an staircase is same like an slab?

1 Answers   EIT,

---

Dear Sir What is the Contraction joint for base Slab

0 Answers   L&T, TES,

---

How do you calculate load bearing capacity of a waffle slab?

0 Answers  

---

---

how to calculate cut length of re-bar in a circle . because we not place same length of re-bar in whole circle maximum in center and minimum at corner so how to calculate middle bars???

0 Answers   Student,

---

Why steel rods are produced only in even dimensions?

0 Answers   Billimoria,

---

Why chairs are provided at slab?

3 Answers   DLF, Kalpakkam, SKYi,

---

Rate analysis for construction of a solid block masonary of size 400x200x200 in C.M.1:5 in superstructure .Compressive strength 5.00 N/Sq.mm Confirming to IS: 12894:1990, with necessary scaffolding, raking of joints and pointing the same. I require rate per Cum.

0 Answers   Alagar Builders,

---

hi , can anybody help me about the following doubt...... what is the difference between clear cover, cover and nominal cover to reinforcement ?

3 Answers  

---

which software better design in structure design or Rcc design(STAAD PRO,TEKLA STRUCTURE)

43 Answers  

---

i have a bar diagram as straigtht bending, but i maked circle bend, how to i justify to others?

1 Answers  

---