Hello Friends
I had my ONGC test today,but it was very bad.But I would
give certain suggestions so that u may not face he problem
which i had.
Be thorough with Electrical Technology.Generators.motors
stators etc.There are 5 questions on that.
There were also good no.of questions from Hydraulic machine
and Production technology.
Then 3 from Strength of materials.And remember the
dimensional quantities.
No Answer is Posted For this Question
Be the First to Post Answer
What are the basis on which the best material for sliding contact bearings manufacturing?
What is the difference between bolt and screw
what is compressor out let pressure siemens v 94.3 a gas turbine ?
two shafts should have same strength? a)dia b)same material c)angle of twist d)twisting moment
What is fission and fusion?
What is the booster in pneumatic.
what is the difference in Gas Welding and Gas Cutting?? Second Question is for Huge Casting which method is used??
What will be the cause of scavenging fire?
which purpose use in air intake system
I am Sunny..I have completed B.Tech(Mechanical).can i apply for Probationary Officer Post in Syndicate Bank 2010.Is that they hire engineers for PO Post?
What are the advantage and disadvantage of using lpg in a car?
What do you know about DG ,A,B,C, D, Check and safety of generator.?