Answer / virendra1981

The size is based on the two factors the lengh ( as the
length will be high the voltage drop will increase )of the
two point & the load current to be flow from the cable .

Answer / naresh chandra jha

it depend upon connecting load and voltage . cable size is
calculated by = (IT^(o.5))/k
where I= max. fault current
T=time to withstand fault current
K=conductor constant , for alluminium k=0.094

Could the power factor on electrical system can affect the registration of the kwhr meter or the CT/PT? 

0 Answers  

---

in alternator permanent magnet generator is also connected on the alternator shaft,then y that PMG voltage is very low as compared to alternator?

1 Answers  

---

What is the d/f b/w MCCB & MCB

6 Answers   ABC, LMN,

---

what is the formula for building wiring to get the main breaker.

1 Answers  

---

Moving Iron instruments are applicable with a) DC only b) AC only c) DC & AC

14 Answers   Bhel, Engineers India, Engineers India Limited,

---

I have tow 200 KVA UPS, both are in parallel mode.My question is that, both are running on battery when power fail, if one of them fail (Eg rectifire fails or some other reason), at thet time reverse power will come to faild ups if it comes then it will harm to failed ups or not? if not then how it protects to faied ups????????????????

1 Answers  

---

what the reson to use phase shift( angle) like (dyn11,Dd5 or Dy0)are usedin power and transsmison line

1 Answers  

---

how do i work out the Amps of a incommer if i am running 1 37 KW motor and a 0,75 KW motor and some solinoids

0 Answers  

---

In a large office how do we calculate required number of light fittings, assuming fittings are 4x18W or 2x36W fluorescent fitting ?

0 Answers  

---

My system is 22kv/3.3kv transformer. client is asking to use NGR, but as we have dedicated Neutral Earthing systems which has a value less than 1 Ohm. So i want solid comparision. Why i should not use NGR as my system is already protected.Can any one help me to get out of this.how should i reply on basis of some great comparision and calculations. Please help

2 Answers   Ariel,

---

what are the causes for strip heater failure ?

1 Answers  

---

short notes on npn & pnp transisitor..........

5 Answers  

---