What is the ruturn loss?
Answers were Sorted based on User's Feedback
In telecommunications, return loss is a measure of power
reflected from imperfections in an electrical or optical
communications link. It is the ratio PR / PT, representing
the power of the wave reflected from the imperfection (PR)
to that of the incident, or transmitted, wave, (PT). For
best performance, the reflected signal should be as small as
possible, meaning the ratio PR / PT should be as small as
possible.Unit is DECIBELS
Is This Answer Correct ? | 11 Yes | 1 No |
Answer / adesh bandhu
RETURN LOSS IS THE PARAMETER OF MATCHING IF THERE IS A 100%
MATCHING IN THE IMPEDENCE THEN RETURN LOSS IS INFINITY
IF 0% MATCHING TEHN RETURN LOSS IS ZERO ,
100% MATCHING MEANS ALL THE POWER IS TRANSFERED THERE IS NO
REFLECTED POWER AND 0% MATCHING MEANS ALL THE INCIDENT
POWER IS REFLECTED BACK
Is This Answer Correct ? | 2 Yes | 1 No |
Answer / ravi durbha
return loss gives the measure of mismatch between source and load impedances.
Is This Answer Correct ? | 1 Yes | 0 No |
Answer / thiru
return loss=-20 log[r].
where r is the standing wave ratio
Is This Answer Correct ? | 1 Yes | 2 No |
what is the diference between High antenna gain and low antenna gain and whivh one is better and why?
Give the typical value of bias current for ca741 operational amplifier.
What is the use of fbus protocol?
the number of factors of 576?and the logic for this question?
How to programme PIC microcontroller.
How WDM works in wireless system...as we say that it works in optical and signals transmitted in this are light signals...??
what are the need of satellites in telecommunication. if satellite no means how can we communicate with others?
What do you mean by trim
explain construction of lvdt?
WHEN +VE VOLTAGE ON THE GATE P-CHANNEL JFET IS INCRESED DRAN CRICUT WILL BE WHAT CONDITION
why rs232 is used in uart when there are many rs devices like rs449 etc . what is the main advantage in using rs232
what is setup time and hold time for a flip flop??