wat should be the main steps for qualifying gate.

0 Answers  

---

Two initially identical samples A and B of pure germanium are doped with donors to concentrations of 1*10, 20 m-3 and 3*10, 20 m-3 respectively. If the hole concentration in A is 9*10 12 m-3, then the hole concentration in B at the same temperature will be

0 Answers   C DAC, CDAC,

---

We are facing the problem of communication failure between seimens drives and ABB DCS. Between drives and DCS on RLM -01 module for communication purpose. We found red blinking i.e error blinking in RLM -o1 module. So we replaced with new one but after one month same problem again came. So again we installed old RLM-01 module. Now also RED blinking is coming but sometimes drives are not tripping. What will be the cause for this problem?

0 Answers   DSPM,

---

Why the actual q-factor of the coil is someexplain what larger than the calculated q-factor?

0 Answers  

---

What is handover and what are its types?

0 Answers  

---

---

Usually we say that capacitors block dc and allow ac. if a capacitior is connect in series with a resistance.. will current pass through the capacitior.... if i doesn't pass..is it due to offering of infinite resistance by capacitor there by acting as a open....

1 Answers  

---

Hall effect can be used to measure

1 Answers  

---

Briefly explain how to get..? maximum resistance can be obtained by using 2 resistors.

4 Answers   Cummins,

---

What are the three stages through which pll operates?

0 Answers  

---

whan type of controller is used in power plant?

0 Answers   DVC,

---

Describe the working of four quadrant chopper?

0 Answers  

---

What is the power capacity of nuclear power plant used in nuclear submarrine?

0 Answers   BARC,

---