What does the "IPX maximum-paths 2" command accomplish? A. It enables load sharing on 2 paths if the paths are equal metric paths. B. It sets up routing to go to network 2. C. It is the default for Cisco IPX load sharing. D. It enables load sharing on 2 paths if the paths are unequal metric paths.

3 Answers  

---

When we use standard access-list?

0 Answers  

---

Why we used Virtual MAC in GLBP

0 Answers   Infosys,

---

Which two steps are required to confound and apply standard access lists on an interface? (Choose two) A. define an access list number and its parameters B. enable an interface to become part of the access list group C. define the number of access lists to be supported on an interface D. copy the access list definition to each interface that will support it

2 Answers  

---

What 2 commands verify end to end communications? A.) Trace B.) debug ip session C.) Ping D.) Route

1 Answers  

---

---

what is the full fom of ping

17 Answers  

---

Identify the command to configure the configuration-register? A.) Router# config-register 0x2102 B.) Router(config)# config-register 0x2102 C.) Router(config-reg)# 0x2102 D.) Router> config-register 0x2102

1 Answers  

---

what is the diffination of bandwidth.

2 Answers  

---

When would you use ISDN? A.) To connect LANs using POTS B.) To support applications requiring voice, data, and video C.) When you need a consistent and very high rate of data speed D.) To connect to IBM mainframes

2 Answers  

---

How is private ip different from public ip?

0 Answers  

---

Which commands will restart the router? A.) router#system exit B.) router >reload C.) router#shutdown D.) router#reload E.) router#(config)reload F.) router#system restart

10 Answers  

---

what is frame relay.and how it is different from isdn

1 Answers   HCL,

---