Answer / powerplant.calculations

CPP : Captive power plant
MPP : Medium pressure power plant
LPP : Low pressure power plant

Refer below link more more idea
https://www.powerplantandcalculations.com/2020/05/introduction-to-power-plant.html

https://www.powerplantandcalculations.com/2020/05/understanding-specific-terms-for-power.html

Our 8mw steam turbine (condensing cum extraction) exhaust steam temperature is high even after taken it in hogger why

1 Answers   Bombay Rayon Fashions,

---

We have Demin Closed cooling water system with expansion tank for cooling oil system. Expansion tank having N2 bladder. Whenever N2 bladder bursts out, Closed cooling water circuit pressure drops and make-up happening, eventhough there is no leaks. And how Circuit pressure drops?

0 Answers  

---

how mony power plants in India

3 Answers  

---

what is natural frequency of turbine shaft .

0 Answers   Thermax,

---

LAPT working in alternator / generator

0 Answers   Power Plant,

---

Why reheater is not used after IP turbine.

3 Answers   Hindalco, SEC,

---

what is the defenation of efficiency in the high pressor boiler? what is the formila of efficiency in the high pressor boiler?

3 Answers  

---

Due to the sensitive earth fault Our Power plant Get Tripped Several Times, It happens in the morning time daily, When temperature rises that means sun rises the earth fault current get lower, in this situation What should I do to get rid of this Problem?

2 Answers  

---

what is CT saturate?and which effect on CT after its saturate?

4 Answers  

---

How do you consider that you can improve and what assistance do you need to achieve this

0 Answers  

---

In one plant id fan and fd fan are used for boiler. boiler is used to heat water after some days they install one tank to heat water by hot flue gases coming out from boiler and then hot flue gases are used to heat the air coming from fd fan before leaving out from chimney . but hot flue gases are not coming out from id fan what might be the reason?

3 Answers   TATA,

---

why high pressure heater will take after sufficient pressure? what happen when high pressure heater will take from COLD REHEAT line at light up time when hp and lp by pass in service.(means can we heater take at low pressure?)

2 Answers  

---