Answer / firoz ghanchi

Residual Solvents in pharmaceuticals are Organic volatile
chemicals that are used or produced in the manufacture of
drug substance or excipient or in the preparation of drug
product.
Residual solvents refer to the amount not removed during
the purification of the drug product.
Organic Volatile impurities are
1.Dichloromethane(600ppm)
2.Chloroform(60ppm)
3.Trichloroethylene(80ppm)
4.1,4-Dioxane(380ppm)
these four solvents are OVI solvents
Remaining solvents are residual solvents.

is there any material other than caffene to calibrate hplc detector

13 Answers   Biocon,

---

I have 1 gram of Diphenylamine and want to make a 10,000 or 1000 ppm solution in methanol. How do I make this?

9 Answers   Midas Technologies,

---

what is least count of a balance? How we find out this? Any formula for least count of Analytical balance?

13 Answers   Acme Formulation, Analytical Solutions, Dr Reddys, Reddy Labs,

---

why KF factor is between 4.5 to 7.5 mg/ml ? why ? why sometime pyridine is used in analysis like in raw material solvent like acetone etc?

11 Answers   Aurobindo, GVK, Sohan Healthcare,

---

What is Rf value& Rx value in TLC?

1 Answers   Abbott,

---

---

What is differences between the Instrument and Equipment

2 Answers   Aurobindo,

---

Dear sir, This is R.Kadambavadani working in a pharma industry. while doing RS analysis of ibuprofen API, unknown peak eluting some times in the 0.6 Min RT. Kindly send me what is the exact reason behind that. also am using ACN the mobile phase.

1 Answers  

---

How are PDA Detector work in HPLC

7 Answers   Agilent,

---

My question about gas chromatography sulfur chemiluminsecence detector. I test unknown sample gas by GC-SCD (calibrated ) and the result of *H2S is 279 PPM , *but when I test the same sample with the GC-TCD (calibrated ) the value of *H2S is 2500 PPM . I'd like to inform you that both GCs are calibrated and have very good operation conditions with stable parameters . the question is if the sample gas with higher H2S over detection limits of SCD detector (1000 ppm). why the result it 279 ppm Best regards

0 Answers  

---

what is classification of elemental impurities? what is risk assement in elemental impurities?

0 Answers  

---

what is the difference between polarimeter lamp and ir lamp

0 Answers  

---

What is the use of ELSD in HPLC?

3 Answers   Anthem,

---