what happens when the spark are introduced before the piston reaches maximum

Question Posted / 29945778

4 Answers
5432 Views
KBR, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

what happens when the spark are introduced before the piston reaches maximum..

Answer / madhav vishwakarma

Knocking are created and piston get damage also unwanted noise created.

Is This Answer Correct ?

10 Yes

1 No

what happens when the spark are introduced before the piston reaches maximum..

Answer / stub

Engine will work normally, some advance is required because it takes time for the flame front and compression wave to travel from the spark plug to the piston face.

However, if the advance is too great than knocking will occur with noise and possible damage.

Pre-ignition is where a cylinder is too hot, compression is to high or has excess deposits in it that cause the the mixture to ignite before the spark with teh same ill effects.

Is This Answer Correct ?

2 Yes

0 No

what happens when the spark are introduced before the piston reaches maximum..

Answer / nishantsingh

It get pre ignite and bcoz of this knocking occurs,this would damage connecting rod and crank shaft.

Is This Answer Correct ?

2 Yes

2 No

what happens when the spark are introduced before the piston reaches maximum..

Answer / himanshu mishra

will cause detonantion
which means unveven or abnormal combustion
lead to
unburnt gases
more maintenance
more carbon residue
more harm to nature
more vibration
less engine life

Is This Answer Correct ?

0 Yes

1 No

Post New Answer

More Mechanical Engineering Interview Questions

What is conduction?

0 Answers

which is more efficient diesel or petrol engine?

4 Answers

i want to know how a dg set run/works and what is strock and what difference in between two and four strock engine.

0 Answers

What type of Voltage should be in the Resistance Welding. Should it be High or Low & Why?

1 Answers

What are the purposes of spiral gear in a purifier?

0 Answers RRB,

plese send me the rrb model questions for JE mechanical

0 Answers Ford,

what is npsh and how to calculate it for a centrifugal pump

15 Answers Essar,

Out of constant pressure and constant volume lines on ts diagram which line has higher slope ? And whether slope is constant or variable ?

0 Answers

What are the causes of high alkalinity in boiler water?

1 Answers RRB,

Q-1-what type of bearing used in system? Q2-MEANING OF BEARING SPECIFICATION-ZZ, C3,RS 2Z ZZNR

1 Answers

Why Diesel Engines are expensive than petrol Engines? Tell the economics of both the engines?

14 Answers Bhel, TATA,

Explain the function of cooling water expansion tank.

1 Answers

For more Mechanical Engineering Interview Questions Click Here