Answer / sourav

It is important to note that our bearing measurements are all done in the following order: Inside diameter (ID) x Outside diameter (OD) x Width (W).

sir i am doing my b-tech mechanical final year. if i attend to the software company job interview if they ask "Why u r going to a software company Y not core?" what i have to answer.

2 Answers   TCS,

---

sir i have to face an interview for marine trainee engineer on 15 sept tell me some related questions which r genrally asked...

0 Answers   Shell,

---

what difference between centrifugal and reciprocating pump.

5 Answers  

---

sir i need section engineer test papers

0 Answers   RRB,

---

how exact reduced the work done by compressor by use of intercooler?

0 Answers  

---

---

• Why only 3 phase?

1 Answers   NTPC,

---

What is Rig floor..?

0 Answers   National Drilling Company,

---

What is forced convection?

0 Answers  

---

can a horizontal mount motor be used vertically?

2 Answers  

---

can a right hand nut be tightened on a right hand bolt?

4 Answers  

---

An employ has after increment has Gross Salary 22000 rupees per month. Earlier he was covered in ESI . now should we deduct ESI from his salary or not.

0 Answers  

---

Two pumps connected in series , what will be the shape of QH curve ?. What will be the shape if they are in parallel.

1 Answers   Ferrari, IGCAR,

---