Answer / penumatsa manikumar

First we have to check load cell resistance , voltage and sensor + Excitation - Excitation ,+ Signal - Signal, + sensor -sensor. we should check all connections at PSB board and terminal outputs. for example some load cells getting resit is 485 +or- 10 and some load getting 845 +or- 10. So voltage also 5v or 24v. note resistance consistent. If not getting in +or- below resistance that load cell OK.above getting that to be check . Then put weight and check calibration zero or span as per requirement.

Answer / bhavesh jaiswal

Firstly we connect Load Cell to Load cell Display.
Check on NO Load Reading.
Then Check a Known weight on it.
If value is same then no need of calibration.
If different then Change setting Feed known load value on it

why we give dedusting steam in feed gas coils in convection section of primary reformer?

0 Answers  

---

what is 3M

2 Answers   Samtel,

---

what is PIV related to diode

1 Answers  

---

What is vendor developement? what is the logistics transport control?

3 Answers  

---

What is Comprehensive AMC cost for 2 TR Split AC & 4 TR Casset AC .( If Unit is 2 Yr Old )

1 Answers   Reliance,

---

How To Operate smoke Detector

1 Answers  

---

Explain why are the major iron and steel industries in india located in eastern india?

0 Answers  

---

What is a plant layout?

0 Answers  

---

What you know about iso 9001?

0 Answers  

---

Why is statistics important in Industrial Engineering?

4 Answers  

---

why data registers are needed in PLC ?

0 Answers   Samtel,

---

formula for convert liter in to pale

0 Answers  

---