in my working site. momentary jerck in electrical supply ocurred frequently which cause of multiple losses in our electrical equipements. how can we protect our electrical machines and equipements in this situation.
- 1 Answers
- 2646 Views
- I also Faced
- E-Mail Answers
Answer / prakash g.r.
You must have a pucca earthing system to avoid such jerk.
| Is This Answer Correct ? | 0 Yes | 0 No |
In ups static switch if i gives the supply at output end it will open the circuit in stactic switch or not if it will open then how it operates.
what is meant by distance protection ? how distance protection relay function ?
what is the difference between brushed alternator ,brushless alternator & permanent alternator ?
What is the difference between bushing and insulators.? what is the creepage distance?
Three set (each phase contain 2 cable of 400 mmsq CU XLPE AWA) of single core cables are connected to 11 KV motor of 14 MW & the switch gear supplay is taken from 11kv feeder & this supplay taken from 275 KV substation. Problem is one pair cable(L3- 2 cable ) getting very hot & gland melted and damaged in switch gear side. the other two cable haven't any more hot(ambient temp only & L3 haveing 95- 100 Degree C. The same problem happened in 275 KV substation switch gear side also where the supply taken for 11 kv switch gear. But here L2 phese cable had problem. Why it is happening like this?. The cable having temperature different at different location from gland side inthe case of 11KV feeder of 275 kv substation. why ?
Define active and passive network?
Why AC loads wont used in DC input supply? and Why DC loads wont used in AC input supply?
How can we determine or find out the proper size of any cable if nothing is mentioned on it.Calculation of size in Sq.mm???
why need of ac exietation in alternater.
what is the acb tripping & closing voltage.
what is demagnetising effect & crossmagnetising effect and how it is related to electrical system?is there any more effects are available or only these two??
why name plate detail HP/KW rating of a motor is different from measured value HP/KW using formula?
-
Civil Engineering (5085) - Mechanical Engineering (4451)
- Electrical Engineering (16632)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
