Answer / l.raghuraman15

In AutoCAD we are drafting the jobs in 2-D which may not
give the clear view of the object. But in Pro-e we can get
clear view of the object in 3-D. By using ANSYS we can save
the materials since we can apply and get results without
destructing the materials.

By using these softwares we are analysing a job without
wasting the material. But eventhough the jobs were analysed
using softwares they are performing a practical operation.
Why? Whether they are checking the results got in that
softwares?

Answer / mustansir pancha

Whatever you draw in autocad can be drafted on an engg
drawing sheet also. The advantage of using softwares is to
make it understandable to a worker too. This is done by
converting the 2-d drawing into 3-D. Thus the skill level of
the worker required reduces.
Ansys software is an analysis software that gives an
approximate answer of whether the product can withstand the
design conditions. The result obtained is multiplied by a
safety factor in the end and thus this eliminates rigorous
physical testing of the product manually, saving time and money.

What are the important operational performance parameters in design of fuel firing equipment ?

0 Answers  

---

What type of pump is commonly used is feed water system in auxiliary boiler?

0 Answers   ABC Inc, RRB, Siemens,

---

Causes of M/E high exhaust valve temperature

0 Answers   Sun Mark,

---

Dear sir/madam, plz sand me techanical test question (mechanical)

0 Answers   Micromatic,

---

What valves are fitted in a four-stroke diesel engine?

0 Answers   RRB,

---

how do you differentiate the while look at drawing whether it is first angle or third angle projection.

2 Answers   L&T, MAHINDRA,

---

What is the difference between Is 2062 material Grade A & B. Which grade is better ?

1 Answers   Thermax,

---

which engine is produced more pollution than other petrol or diesel?

10 Answers   GWJ,

---

effect of temperature on stainless steel,aluminized steel,chromium at (500C-750C)-required for project work on silencer 1.thermal conductivity 2.heat conduction 3.mechanical strength 4.temperature to weight ratio urgent

0 Answers   Essar,

---

why so dangerous charging compressed gas in to oil compressor

1 Answers  

---

What is the difference between Muff Coupling and Screwed Coupling with Cotter pin used in pump line shafts.

0 Answers   DAE,

---

hi sir my name is srikanth plz send me question papers

0 Answers  

---