A motor is taking 15 Amps at no load and 60 Amps at full load. and a valve has

A motor is taking 15 Amps at no load and 60 Amps at full load.
and a valve has to open 10% at full load and 80% at no load.
How to draw ladder logic.(PLC).

Question Posted / david

2 Answers
6162 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

A motor is taking 15 Amps at no load and 60 Amps at full load. and a valve has to open 10% at full..

Answer / amit gathiya

YOU NEED A CURRENT TRANSDUCER AT YOUR MCC WHICH CAN GIVE YOU
THE 4-20mA SIGNAL WITH 0 TO 70Amps. proportionally.
USE LESS THAN & GREATER THAN BLOCK LOGIC FOR OPEN & CLOSE
THE VALVE.

Is This Answer Correct ?

7 Yes

0 No

A motor is taking 15 Amps at no load and 60 Amps at full load. and a valve has to open 10% at full..

Answer / rahul nayak

U dont need any plc logic for such application since u can
do this project with the help of simple transducer which
will gives the mA o/p with respect to ur Amps. & just i/p
converter which will help u to open ur positioner valve.

Is This Answer Correct ?

5 Yes

0 No

Post New Answer

More Instrumentation Interview Questions

where Pirani gauges are uesd in case of pressure measurement?

3 Answers

Reasons for using seal pots:

1 Answers

How much voltage we are using at switches?

4 Answers Edac,

what is interface level and how it is calibrate?

0 Answers

What is Cryogenic?

2 Answers

god evening sir i am studying m.sc(tech)electronics &instrumention.am i elegible to all industies

0 Answers

what is difference between wheatstone bridge, pirani gauge and strain gauge ??? explain its principle and working

4 Answers

what is the difference between transmitter and smart transmitter ?

4 Answers Aditya Birla,

In VVVF DRIVES VOLTAGE IS ALSO VARY WITH THE FREQUENCY. HOW? WHAT IS THE DIRECT FORMULA RELATING THESE TWO.

0 Answers India Cements,

An electronic p controller has an input range of 1-5v, and output range of 4-20mA, while testing a step change of 0.4 was applied at the input , the PB setting was 50% ,what should be the change in the output ?

1 Answers Reliance,

what is procedure of calibration of remote seal transmiter, botom to top flanch 850mm, fluid liquid density .73, transmiter fixed on a fractionation colum, under vaccume 10mbar

4 Answers

if we open the inlet of an air regulator ,how it will affect the out put of regulator? (out put of regulator is using to operate an on-off valve.it is an air to open valve,and valve is in open position.my doubt is air regulator will hold the valve in open or not,if there is no consumption or leak in regulator out put side ,we only loose the input pressure.)

4 Answers Asian Paints,

For more Instrumentation Interview Questions Click Here