why the supply frequency used in America is 60Hz while that
used in India is 50Hz?,
Answers were Sorted based on User's Feedback
Answer / kyle condran
Why north America NTSC and Europe PAL
Why Metric and IMperial.
it is just the system choosen
Is This Answer Correct ? | 2 Yes | 2 No |
Answer / rajendar
RPM at 60 Hz is more and RPM at 50 Hz is less.
Is This Answer Correct ? | 0 Yes | 0 No |
Why trim span ? How?
why used three wire in RTD.
Anybody can tell me how to convert mmHg2o /psi to scfm please give me formula of conversion
What is re-latch the manual trigger in solenoid valve
0 Answers Valvitalia Systems Division,
SIR MAY I KNOW IF RADAR TYPE LEVEL TRANSMITTER SHOWING IN THE FIELD 0 % LEVEL AND IN DCS SHOWING 100% THEN WHAT IS THE CAUSE I CLEAN THE CHAMBER & TAKEN ONLINE BUT ONLY ONCE ITS BECOME ZERO IN DCS BUT AGAIN 100% SHOWING IN DCS,THEN I REMOVE THE POWER SUPLLY AND CONNECT IT AGAIN .IS IT OK BUT STILL IN THE DCS ITS 100% AND ON THE DISPLAY ITS INITILAZIATION PLEASE HELP ME READRING THIS?
In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?
ORP sensor working principle?
Calibration procedure for water rotameters
What is the minmum distance between the electrical panel and Instrument panel
The document / drawing that is primarily used in depicting the “Bill of Materials (BOM)” of piping system is the
Dear All can any one told me that VFD Make ABB Model ACS800-01 used for dual Source like 1.DC Source applied at terminal UDC+,UDC- 2. 3 phase 400AC,50Hz
HOW FOREIGN CONTROL SYSTEM CAN BE CONNECTED WITH DCS?