How to conduct the Hydro & Pnumatic test as per DIN & ASME
sTANDERS?
Answer / ankur sahu
first create a loop in which pressure all over is constant .
then make all vent open to remove all air inside the loop
and blind the end of the loop with required thickness. then
filled water and maintain pressure 1.5 times of the design
pressure.
Is This Answer Correct ? | 4 Yes | 0 No |
i am going to appear for section engineer which is conducting by RRB chennai. i want some model question papers my emai ID is chakku_mech10@yahoo.co.in
The lowest allowable insulation resistance?
what is the purpose of planetry gears.
What are mechanical safeties in DG sets?
what is the use of choper motor in pyrometer ?
What is fuel oil viscosity, specific gravity?
Hi.. I am studying Mechanical Engineering.. And I am going to prepare for an interwiew of Caritor a software company.. so pleaz tell what i want to study in software and how I should prepare???
what is meant by parallax error
how piston moves from bdc to tdc during compression stroke. which force acted to compress the fuel at pressure....
What is flash point
what will be the min curvature ratio for Round Bar dia. 1” size in material grade AISI 4330, Yield strength 115KSI Tensile 140KSI?
What will happened if two gear boxes in parallel are working with different motor speeds?