if a 3phase 100kva distribution transformer , 400 v,50
hz, 4-wire system is loaded at 160 k.w mostly 1-phase
Lighting & Airconditioning split a.c load what will be the
net effect on the power system in terms of voltage,
powerfactor, current , efficiency of xformer
No Answer is Posted For this Question
Be the First to Post Answer
why we step up voltage for reducing the loss, even if voltage and current are proportional anr resistance remains same
Is there any Institution (Not AMIE)for giving B-Tech/M-tech in Electrical engineering for those who r in service? Give the details please.
why do some transmission towers have two insulators at one side and three insulators at the other side
can any one explain me the where is the use of plc and scada
What type of tranformer generaly at soft wares like capacity 2000 kva 1800 kva etc iam confused it CT or PT OR distribution tranformer
why maintenance batteries used in DG sets not in MAintenance free Batteries.
We have two Al.busbars each of size 125mm*10 mm connected in parallel.To increase the current rating ,can we connect third busbar of size 100mm*10mm in parallel to existing two busbars?In my opinion ,if we connect busbars of different sizes in parallel,then the busbar of lowest size will take much current.So this type of paralleling should be avoided .Am I correct?
how to define tell me about self
What is potientiometer.What is the use of it.
my self i am raghu working as tech.. in my college the maximum demand is 211 kva presently we are using 12kva capacitors the target power factor is .95 so what capacity of capacitor banks should i install
In power transformer tappings are provided on A high voltage side B low voltage side C In middle of both the windings D both high and low voltage side
what will hapen if secodery circuit is open of current transformer