What happens when the hold-down timer expires?
A. Routes are flushed from the routing table after the flush
timer expires
B. Routes are flushed from the routing table immediately
C. Routes are never flushed
D. A triggered update will reset the hold-down timer
Answer / guest
Answer: D
A triggered update is one of the instances that can reset a
hold-down timer after it expires.
| Is This Answer Correct ? | 1 Yes | 8 No |
How many networks will be advertised using route summarization within an OSPF network if you are given the following networks? 192.108.168.0 192.108.169.0 192.108.170.0 192.108.171.0 192.108.172.0 192.108.173.0 192.108.174.0 192.108.175.0 A. 1 B. 2 C. 3 D. 4 E. 5
What category or categories does Client/Server fit into the following Job Aid? Name of Protocol Type of Protocol # of Users # of Hosts or Servers Comments
What should be looked at first to determine if a customer should switch from a hub environment to a switched environment? A. Investigate the number of broadcasts B. Investigate the number of collisions C. Determine what routing loops are present D. Determine which switching type is being used by the hubs
Which condition does not create LAN media problems? A. Protocol doesn?t scale well B. Long wait for the token C. Excessive collisions D. Too many devices
SNMP agents are: A. Management devices B. NMS (Network Management Stations) C. network devices such as routers, switches, or hubs D. PDUs
What address is 12 hexadecimal, resides in the Data-Link layer, and is burned in the ROM by the manufacturer.
When are SNMP traps sent? A. When the SNMP manager wants to perform remote configuration on a networking device B. When an SNMP agent wants to inform the SNMP manager about a change of state on the networking device C. When the SNMP manager wants to access large chunks of data D. When the NMS wants to share trap information
Regarding a full-mesh network and a partial-mesh network, what is the most accurate statement? A. Split Horizon will not work on a full-mesh network B. A full-mesh network is more expensive because more routers are used C. A partial-mesh network is less expensive because less virtual circuits are used D. Broadcasts are more plentiful on a partial-mesh network
ISDN is referenced by a suite of ITU-T (International Telecommunication Union Telecommunication Standardization Sector) standards encompassing what three layers of the OSI reference model? A. Physical B. Data Link (LAPD) C. Data Link (RMON) D. Network (Q.930 and Q.931)
EIGRP was developed to improve what two protocols? A. OSPF B. RIP C. BGP D. IGRP
What PPP frame initiates the network layer protocols to be used during a connection?
Match the following devices with the correct description. A. Switch 1. Operates at the physical layer and extends the cable as if it is a single cable. B. Router 2. Operates at the physical layer and connects all connections into one device or concentrator. C. Repeater 3. Operates at the network layer and can filter both hardware and network addresses. D. Hub 4. Works at the Data-Link layer and transmits a digital signal only to the specific port where the destination MAC address is located.