what is setup time and hold time for a flip flop??

Categories >> Engineering >> Electronics Communications
Suggest New Category

Question Posted / pari

5 Answers
8664 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

what is setup time and hold time for a flip flop??..

Answer / k.shanmugasiva

Setup time :It is the minimum time before the clock edge
the input should be stable.

Hold time:It is the minimum time the input should be
present stable after the clock edge

Is This Answer Correct ?

12 Yes

2 No

what is setup time and hold time for a flip flop??..

Answer / pari princess

yes its rite...bt wats the requirement for the setup nd hold
time violations???

Is This Answer Correct ?

0 Yes

0 No

what is setup time and hold time for a flip flop??..

Answer / vinit panchal

when we are giving a clock pulse to flip flop then it will produce output. time require between giving a clock pulse and producing output is called the setup time after producing output how much time it should be hold the output it is called the hold time.in another way we can say that
in rising edge in clock pulse it is called setup time and the time between rising edge and falling edge is called the holding time.

Is This Answer Correct ?

0 Yes

1 No

what is setup time and hold time for a flip flop??..

Answer / saifi4u01

setup time:- it is the time taken by the flip-flop to change the value of it's output about 50%.
hold time:- when input hasbeen changed then the time taken by the flip flop to decrease its output value about 50%.

Is This Answer Correct ?

1 Yes

3 No

what is setup time and hold time for a flip flop??..

Answer / chandru

no idea

Is This Answer Correct ?

0 Yes

5 No

Post New Answer

More Electronics Communications Interview Questions

why job after btech without going to further education?

7 Answers Wipro,

Explain how to convert design gray to binary code?

0 Answers

what is the minimum and maximam trace width in PCB design? why trace is measured in mils? what is the use of via? why the crystal oscillator is placed near chip?

0 Answers Wipro,

i m selected in AAI JE. my interview is on 25 sept. 2010. i don't hv any idea abt aai interview. can anyone help me, i want to know interview qus of aai. so pls help me... my e-mail id -- mailmanish_kumar@yahoo.co.in

0 Answers

Explain what kind of negative feedback is present in a noninverting op-amp.

0 Answers

What is memristor? How many modes it works? Also what is its advantage? How it differ from others & why the name evolve? & What is its uses?

0 Answers

Explain why regeneration is not possible in semiconductor

0 Answers

Pls tell me when will coming ssc scientist assistant result...how many marks for elgilibity.. Am a minority girl oc

0 Answers

How to convert binary to excess 3 code and vice verse?

0 Answers

What is DNS server and resolver

1 Answers Aricent,

Explain why are the 2 input terminals of an op-amp are called as inverting & non-inverting terminals?

0 Answers

i want do telecom protocol development course from hyderbad convergence training school so what is the scope after doing that course and will i get a good job after doing the course and what will be the minimum package

0 Answers BSNL,

For more Electronics Communications Interview Questions Click Here